|
|
Post by Jonny tsunami on Apr 12, 2014 23:28:14 GMT -5
|
|
|
|
Post by chevtech on Apr 13, 2014 18:10:53 GMT -5
Should be much stronger now!
|
|
|
|
Post by Jonny tsunami on Apr 14, 2014 20:31:47 GMT -5
well I made a few miss calculations.. didn't get the hangers right. miss measured for the center axle so it didn't fit. so all my hangers but the last two need to come off, and the pivot hangers need to be made about 1 1/2 inches longer so the pivot will pivot all the way and not let the spring hit the frame. ugh the set backs......   |
|
|
|
Post by Jonny tsunami on Apr 20, 2014 23:19:20 GMT -5
got some new brackets made, cut all the others off and got one side of the trailer done. welded in some center plates cause there so tall, just got 3 more to weld on.   |
|
|
|
Post by Brennerbadboy on Apr 21, 2014 22:27:38 GMT -5
looking good Jonny, keep it up
|
|
|
|
Post by Jonny tsunami on Apr 27, 2014 22:08:56 GMT -5
got the axles all buttoned up.  on all 6 now  |
|
|
|
Post by Rock Dawg on Apr 28, 2014 12:21:08 GMT -5
Nice, I almost needed it this weekend ;-).. I'm using one of those drivelines now for the blazer ;-(.... Thanks again!
|
|
|
|
Post by Jonny tsunami on May 10, 2014 22:41:34 GMT -5
got some more done today welded the dove tail on, also had a buddy wire the lights for me   |
|
|
|
Post by Jonny tsunami on May 18, 2014 22:40:44 GMT -5
|
|
|
|
Post by Jonny tsunami on May 24, 2014 22:06:28 GMT -5
getting the sides done, doing it stake pocket stile, more for just being able to ratchet strap stuff down any where along the outside edge   |
|
|
|
Post by Jonny tsunami on May 27, 2014 20:39:45 GMT -5
long day welding but I'm almost done.  |
|
|
|
Post by poorboy1 on May 27, 2014 23:33:31 GMT -5
Back of the trailer sure looks close to the ground. is it gonna make it out the drive way without scraping?
|
|
|
|
Post by Jonny tsunami on May 28, 2014 10:45:36 GMT -5
Back of the trailer sure looks close to the ground. is it gonna make it out the drive way without scraping? on level ground with the trailer level it sits 12 inches off the ground. I wouldn't doubt that I will scrape it from time to time. its 6 foot from the rear tire to the back, and about 7 1/2 feet from the front tire forward minus the tongue. everything I haul will be up on the flat part with the rear tires just at the crest of the tail. except for the crew cab, the rear tires will be riding on the dove tail part. |
|
|
|
Post by Jonny tsunami on Jul 20, 2014 22:53:32 GMT -5
getting the deck done.   |
|
|
|
Post by Jonny tsunami on Aug 2, 2014 19:22:45 GMT -5
so heres a pic of it mostly done still need to replace the upper deck. and now after testing its capacity the dove tail bent down a tinny bit so I will try to floor jack it up when loaded and add some gussets where I should have it the first place, silly me I was in too much of a hurry...  |
|
