|
|
Post by Dicenn on Nov 6, 2012 14:32:05 GMT -5
My friend wants to swap out his 3.0 for a 22re. Is the tranny the same? Will the 22re bolt upto the v6 tranny? Other then swapping out the wiring harness and computer is there any thing else I'll need?
|
|
|
|
Post by stefanh on Nov 6, 2012 15:18:18 GMT -5
You need to switch the harness and computer, if I remember right I think all you have to do is switch out the bellhousing but I'm but to sure on that one
|
|
|
|
Post by mudmaniac3 on Nov 12, 2012 22:04:49 GMT -5
I don't think that the 22re bell housing will work but i'm not sure thats right.
I know the motor mounts are in different spots
wiring, exhaust, ecu, starter, radiator hoses, air intake tube and MAF
|
|
|
|
Post by stefanh on Nov 13, 2012 0:07:50 GMT -5
I think the 22ret works with the v6 setup but I'm sure its a different pattern though. So pretty much gut the whole thing and swap everything for a 22re or find a wrecked truck an cab swap it
|
|
|
|
Post by toyotaguy on Feb 6, 2013 1:56:47 GMT -5
you have to swap trans, t-case everything! the 22ret used a R151F which is a v6 5spd that uses a 4cyl case, but the 22RE only bolt to a 4cyl tranny. just about everything is different.  |
|
|
|
Post by bleakhorizon on Feb 7, 2013 22:30:48 GMT -5
looking for better engine? or cheaper? whatever, best i could think of would be find yourself a good lower milage cressida Inline 6, pretty much same engine as the supra 6
copy and past from pbb
The bell housing from a N/A 7m-ge supra manual transmission will bolt up to a W or G series 4 wheel drive transmission and the 7m and 5m blocks. W58 is the transmission code for the needed bell housing.
lots of info, and if your not looking for a turbo supra motor, shouldnt be TOO HARD, to find a M motor... looking into this myself..
I say, unless he has more time than money (i do lol) hes going to be rewiring anyway... go with a bigger engine...
|
|
|
|
Post by mudmaniac3 on Feb 10, 2013 22:57:07 GMT -5
i would never swap in a 3.0 they are an all around bad motor. make little power, suck the fuel, and have head gasket issues out he wazzoo. I had a 3.0 in my daily driver 4runner and I just swapped a 3.4 in a few months ago and it was without a doubt the best thing that ever happened to that thing. tons more power, and better mpg. even with no 02 sensors I still got 21 on the freeway as where before i was lucky to get 18.
if he has a 22re might as well swap in a 2rz or 3rz they have a considerable amount of power for a 4cylinder and can take some abuse. plus it will be the easiest swap because you can you the same trans if it had a w56. I have one in my scout 5 wires was all i had to wire but i have a stand alone harness
|
|
|
|
Post by bleakhorizon on Feb 11, 2013 16:10:00 GMT -5
im pretty sure OP stated he HAS a 3vze and wants to swap it with a 22re... so no more v6
|
|
|
|
Post by mudmaniac3 on Feb 13, 2013 22:26:50 GMT -5
I'm dumb and can't read whoops
|
|
