|
Post by nwoleman on Dec 26, 2011 16:35:06 GMT -5
|
|
|
Post by nwoleman on Dec 26, 2011 16:35:57 GMT -5
|
|
|
Post by nwoleman on Dec 26, 2011 16:36:33 GMT -5
|
|
|
Post by nwoleman on Dec 26, 2011 16:37:20 GMT -5
|
|
|
Post by nwoleman on Dec 26, 2011 16:37:55 GMT -5
|
|
|
Post by nwoleman on Dec 26, 2011 16:38:33 GMT -5
Finally some pics.
|
|
|
Post by bleakhorizon on Dec 28, 2011 23:18:09 GMT -5
yee haw.. looking good.... looks like yea might need to get a smaller dist cap and external coil though, that thing is huge lol... shes gona rip with that motor in there for sure
|
|
|
Post by nwoleman on Jan 1, 2012 8:31:43 GMT -5
Yeah i don't think they make a bigger cap than the one i got! I dohave about an inch of clerance ya just can't see it. Thanks bleakhorizon!
|
|
|
Post by WILLYNILLY on Jan 4, 2012 8:43:34 GMT -5
Cool!! Just out of curiosity how come you didnt clock the tcase up further? I bet if feels good to have it all tucked in there.
|
|
|
Post by nwoleman on Jan 7, 2012 7:35:38 GMT -5
I did have it clocked all the way up and it wouldn't fit. The torsion bar ithink it's called would push the tranny/ t/c out of alighnment on all three adjustment's so i put it back stock till i SAS it. Thanks. Got all the hoses and lines hooked up and the tranny shift linkage done. Eliminated a bunch of wiring. Got to finish the wiring and do the driveline. Should be trying to fire it next week.
|
|
|
Post by nwoleman on Jan 15, 2012 8:32:18 GMT -5
well i got it started. Found out the fuel pump is bad so i'm putting an inline pump in. Made the driveline, now trying to get the right adapter u joint for the back. Need to tighten up the shifters a lil bit and get the electric fan hooked up.
|
|
|
Post by nwoleman on Jan 22, 2012 10:14:31 GMT -5
Electric fan is installed and working. It runs and sounds good! Had to replace the alternator. Still can't put the driveline in cause apparently they don't make an adapter u joint for A FORD RANGER TO TOYota 4runner! WTF! hopefully figure out a solution in the next day or so. Also need to run exhaust.
|
|
|
Post by Buzzer on Jan 22, 2012 13:00:13 GMT -5
What size are the 2 u-joints?
|
|
|
Post by chevtech on Jan 22, 2012 19:41:19 GMT -5
Why didn't u keep it fuel injected?
|
|
|
Post by nwoleman on Jan 23, 2012 8:35:35 GMT -5
I figured it would be easier to carb it. Not sure what size the u joints are? The back one is stock for a 93 toyota 4runner and the other one is from a 2wd ranger(late 80's early 90's probably)?
|
|