|
Post by Leeland on Sept 18, 2011 21:44:38 GMT -5
Front plastics were painted blue for some reason. Stripped them and painted them black. Still got to get rid of the yellow and waiting on the new black seat cover. I found rear tires from a banshee just need some front tires and a new ohv tag and I'll be ready to play.
|
|
|
Post by Leeland on Sept 18, 2011 22:25:22 GMT -5
Couple nights ago some stupid punk stole my gas can for it. Had mix in it, mixed a little rich so I hope the stupid mofo put it in their car so it smokes. This is twice now stupid punks have hit our normally quiet neighborhood since I've been home.
|
|
|
Post by scotts90ranger on Sept 18, 2011 22:34:19 GMT -5
I just happen to have a set of tires with wheels for a Yamaha I believe (I'll look in the light tomorrow) that I would let go fairly cheap... backs are kinda worn, fronts are ok. I might even have a spare gas can you could have, I think I have more than I can use...
|
|
|
Post by Leeland on Sept 18, 2011 22:42:28 GMT -5
I'd appreciate it. Looking for a 21-22 diameter by 7-8 width on a 10" rim. Some one changed the rear hubs so I can run front and back banshee wheels just been hit and miss finding crap. If you got any other yamy stuff I got a list of parts I'm looking for.
|
|
xj4play
axle snapper
Rock_yota
Posts: 196
|
Post by xj4play on Sept 18, 2011 23:53:54 GMT -5
what kind of Yamaha parts u looking for?
|
|
|
Post by Leeland on Sept 19, 2011 0:21:38 GMT -5
Banshee rear caliper, brake line and master cylinder. Older j arm banshee knuckles complete with rotors and calipers. Pretty much banshee or blaster stuff to convert the front to disks and make the rear work again. Need a air filter as well and front fenders but the fenders are low on the list.
|
|
|
Post by Leeland on Sept 22, 2011 1:17:31 GMT -5
Thanks Scott. Fronts did what I need them to do.
Picked up a air filter and the black seat cover came today. Looking forward to getting it installed tomorrow.
|
|
|
Post by Leeland on Sept 22, 2011 18:40:58 GMT -5
Got the seat cover put on and some of the yellow off the engine. It's looking much better to me than when I got it. Not hard to beat this
|
|
|
Post by scotts90ranger on Sept 22, 2011 19:12:24 GMT -5
Looks good!
|
|
|
Post by Leeland on Sept 27, 2011 22:44:03 GMT -5
Took a lot of work getting the yellow off but it's done and painted. Painting the frame black hammer coat real quick while it's disassembled, going to have to last till I can afford to have it powder coated forest green metallic. Finally got a lead on some cheap banshee parts I want for the front but I'm going to have to suck it up and buy the spindles from eBay but even then I should have 100$ or less in my disk brake conversion.
|
|
|
Post by Leeland on Sept 28, 2011 22:19:10 GMT -5
Almost have it together with a fresh coat of paint. The total vested price of under 150$ at this point.
|
|
|
Post by Leeland on Oct 1, 2011 2:19:32 GMT -5
what kind of Yamaha parts u looking for? What kind of parts do you got laying around?
|
|
|
Post by Leeland on Oct 24, 2011 21:23:41 GMT -5
Got to ride a little yesterday and it was pretty fun, really got to get the brakes taken care of. Stopping is always good.
|
|