|
Post by MudHog on Sept 7, 2008 22:28:57 GMT -5
|
|
|
Post by MudHog on Sept 8, 2008 19:24:54 GMT -5
anybody know if i can bypass the wires goin into the hand control for the clutch?i wanna put a different handle on,but the one on there has wires goin to it so you can only start the bike with the handle pulled in,,i dont wanna have to spend alot on a nother wired lever,,,,or can i just pull them out and wire them together?will that hurt it in anyway?
|
|
|
Post by 96zjlarado on Sept 24, 2008 18:07:46 GMT -5
depends on if its normally open or normally closed switch. i'm assuming it's probably normally open so splicing the wires together would do the trick. what i would do is just cut them off and try to start the bike. if it starts, leave it alone. if it doesn't then splice them together.
|
|