|
Post by poorboy1 on Jan 7, 2012 11:59:34 GMT -5
As most weekends I am out in the shop today. Hoping to get the rear welded up, the front assembled and maybe some skid mounting done.
I have Leadfoots jack stands pulled out so I need to get those shuttled back to him. If nobody that lives by him comes out I can run them back, he isn't too far from me.
|
|
|
Post by Leeland on Jan 12, 2012 23:44:44 GMT -5
Found work finally and it's been tying up most of my week ends or I probably would have grabbed them and brought them back.
|
|
|
Post by poorboy1 on Jan 13, 2012 22:46:31 GMT -5
Will be in the shop tomorrow. The plan is to try and finish up the skid mounting, reinforcing the rear link mount, install rear shocks, Maybe get to the bump stops.
Its gonna be a cold one.
|
|
|
Post by poorboy1 on Jan 14, 2012 11:28:11 GMT -5
yup, its cold. Heading out to get propane.
|
|
|
Post by poorboy1 on Jan 20, 2012 19:10:21 GMT -5
Work plan for tomorrow.
1. Try to get steering installed 2. finish gussets on skid frame 3. replace right side rock slider 4. mock up rear driveline 5. measure for front driveline
Might be a little ambitious, but I need to get this finished up.
|
|
|
Post by stefanh on Jan 20, 2012 22:12:01 GMT -5
How late are you gonna be out there? I might stop by if your out there later not much I xan do but it's always fun to supervise
|
|
|
Post by poorboy1 on Jan 20, 2012 23:34:51 GMT -5
usually out there until 3 or 4 maybe later.
|
|
|
Post by poorboy1 on Jan 29, 2012 21:53:39 GMT -5
Thanks for the help Josh and Charlie.
We got a temporary driveline in the rear to check clearances, right cab corner and rock slider has been replaced. The steering ram parts are welded on and gussetted and teh under belly supports have been welded. Also got the front brakes installed on the axle.
|
|
|
Post by Buzzer on Jan 29, 2012 22:40:10 GMT -5
Wish I'd have known.. just sat around the house all day...
Good Job!
|
|