|
|
Post by MudHog on Dec 26, 2011 18:14:17 GMT -5
|
|
|
|
Post by Bri&Bub Off-Road on Dec 26, 2011 20:43:33 GMT -5
looking good.  |
|
|
|
Post by Buzzer on Dec 27, 2011 12:47:25 GMT -5
|
|
|
|
Post by MudHog on Dec 29, 2011 11:21:35 GMT -5
so,i was lookin at front of jeep,,and the driver side front tire stick out further than passenger side,,tires wear is even on both tires,,what would cause this?driver tire sticks out about 2" more than passenger tire,,or is this just the way it sits normally?
|
|
|
|
Post by MudHog on Dec 29, 2011 11:27:59 GMT -5
here is a couple pics of the way it sits driver side  passenger side  |
|
|
|
Post by MudHog on Dec 29, 2011 11:29:10 GMT -5
maybe an allignment issue on passenger side?
|
|
|
|
Post by Buzzer on Dec 29, 2011 11:34:58 GMT -5
The rim could have a diffrent back spacing, even though it looks the same
|
|
|
|
Post by MudHog on Dec 29, 2011 11:42:03 GMT -5
just went out and measured backspacing,,both have same back spacing distance,,but looks like passenger tire sits at a bit of an angle
|
|
|
|
Post by Bri&Bub Off-Road on Dec 29, 2011 11:42:21 GMT -5
if the rims are the same size then the track bar needs to be adjusted out a little to push the axle over a little. it will wear out the rear tires a little faster being off like that.
|
|
|
|
Post by MudHog on Dec 29, 2011 12:00:33 GMT -5
i looked at the track bar,,not adjustable,,stock track bar with 3" lift would pull axle over to drivers side,,looks like i need to buy a adjustable track bar,,makes sense now,,,maybe that is why i have a wobble at 45mph?gonna order track bar tomorrow...
|
|
|
|
Post by MudHog on Jan 3, 2012 22:04:02 GMT -5
removed fender flares and did some fender trimming  |
|
|
|
Post by WILLYNILLY on Jan 3, 2012 22:06:02 GMT -5
nice work!!! I like it better without the plastic fenderflares anyways.
|
|
|
|
Post by MudHog on Jan 3, 2012 22:08:10 GMT -5
|
|
|
|
Post by MudHog on Jan 11, 2012 18:35:17 GMT -5
i figured out part of the problem with the passenger wheel,,the wheel bearings are shot...so in a few weeks i gotta order some bearings and put em in....
|
|
|
|
Post by MudHog on Jan 12, 2012 16:34:47 GMT -5
got the hub out,,should get the new hub and bearing assembly next week,,   |
|
