|
Post by Jonny tsunami on Jan 3, 2015 17:10:34 GMT -5
dana 60, 1350 yoke. If anyone comes across one, been looking at u pull it and nothing so far. rear dana 60s seem to be pretty hard to find. found one on a old 69 chevy truck but it was a weird 10 spline yoke. the only right one I have found was on a 72 chevy truck. all the fords are always 1330, even the f250s.
also if anyone has a 1350 drive line. I could use that too, any length is good, need it for the front.
I have a extra 1350, 32 spline, np205 yoke for trade on it as well.
nothing I need yet, just keep an eye out for me.
|
|
|
Post by blk01ram on Jan 4, 2015 2:41:39 GMT -5
What are they from the front D60? Not sure what size it is, but I have the one that came with my D60 in my garage floating around somewhere. I replaced it with a 1410 one, it'll take a couple of days, but I'll look and see if I can find it. If it will work for you, you can have it, I don't need it.
|
|
|
Post by Jonny tsunami on Jan 7, 2015 0:11:53 GMT -5
What are they from the front D60? Not sure what size it is, but I have the one that came with my D60 in my garage floating around somewhere. I replaced it with a 1410 one, it'll take a couple of days, but I'll look and see if I can find it. If it will work for you, you can have it, I don't need it. probably a 1310 if its stock and off the front. but ya never know basically you can get a 1350 yoke from a rear 60 and put it on the front 60 I haven't broken my 1330 set up yet, other than twisting a driveline in half, but I'm sure I will need to upgrade sooner than later.
|
|