kevinj
rock crusher
Posts: 272
|
Post by kevinj on Aug 26, 2013 14:13:48 GMT -5
|
|
kevinj
rock crusher
Posts: 272
|
Post by kevinj on Aug 27, 2013 20:58:07 GMT -5
Template for aluminum interior done Rust dug out and filled in, backing in
|
|
kevinj
rock crusher
Posts: 272
|
Post by kevinj on Aug 27, 2013 22:51:43 GMT -5
Waited to long to pull my stencils so they stuck badly, should clean up fine though. The over spray seems to be cleaning up fine also. Bad lighting but you get the picture.
|
|
kevinj
rock crusher
Posts: 272
|
Post by kevinj on May 2, 2014 22:53:14 GMT -5
Finally nearly done. I've replaced the engine (thanks johnny tsunami). Rebuilt the carb, Rebuilt the trans, rebuilt the rear CV and swapped to 1410 u joints and a GMC 2 1/2 slip yoke. Replaced all fluids and any leaky seals. t-case seals. Painted the axles and under carriage. Repainted from header to tail pipe. Rebuilt the back of the tub and body mounts. Poser front bumper. Removed all rust. Bed lined everything inside and out. All electrical has been gone through. Steering fixed. Made a few new break lines. Still need to make new mounts for the hard doors and seal the hard top and a few small painting things. Wheels could use some attention. I still need a rear hatch if anyone has a hook up on one and the my winch needs mounted. Basically ready to go.
|
|